Some features cannot be milled, no matter how good the machine. A square internal corner has no radius for a round cutter to follow. A slot 0.3 mm wide in hardened tool steel would break any cutter small enough to enter it. A deep, narrow cavity in a die block is beyond the reach of a rigid tool. For these, the answer is electrical discharge machining, which removes metal with controlled sparks instead of cutting force.
How EDM removes material
An electrode and the workpiece are both submerged in a dielectric fluid and brought very close together without touching. A voltage across the gap breaks down the fluid and a spark jumps, vaporising a tiny crater of metal from both surfaces. Repeat this thousands of times a second with servo control of the gap and the electrode erodes its own shape into the workpiece. Because there is no mechanical cutting force, hardness is irrelevant: hardened tool steel at 60 HRC erodes as readily as annealed stock.
Wire EDM
In wire EDM the electrode is a continuously fed brass or coated wire, typically 0.1 to 0.3 mm in diameter, threaded through the work and moved along a programmed path. It cuts through the full thickness like a bandsaw that never dulls, and it leaves an internal corner radius equal to half the wire diameter plus the spark gap, which is a fraction of a millimetre. That is why wire EDM is the standard route for punch and die sets, extrusion dies, gear and spline forms, and any profile with sharp internal corners.
Its characteristic strengths are accuracy in the order of a few microns, tapers cut by tilting the wire, stacks of identical plates cut in one pass, and no burr worth speaking of. Its limits are that it must cut through the material from a start hole or an edge, so it cannot produce a blind pocket, and that it is slow compared with milling on anything but thin or hardened work.
Sinker EDM, or spark erosion
Sinker EDM uses a shaped electrode, usually graphite or copper, which is machined to the mirror image of the cavity wanted and then sunk into the workpiece. It makes blind features: mould cavities, deep ribs, keyways inside bores, sharp-cornered pockets and the slots left when a broken tap has to be removed without damaging the thread. Finishing settings produce surfaces down to a mirror finish, which matters for injection mould tooling where the cavity surface becomes the part surface.
The cost driver is the electrode. It has to be designed, machined and often made in roughing and finishing versions, so a one-off cavity carries real preparation cost. For tooling that will run millions of parts, that cost disappears into the piece price.
Choosing between them, and against milling
- Through-profile with sharp internal corners, hardened or not: wire EDM.
- Blind cavity, deep rib or internal keyway: sinker EDM.
- Part already hardened and heat treatment cannot be reversed: either EDM process, since no cutter will touch it cleanly.
- Open geometry in soft material with normal corner radii: mill it. EDM would be slower and dearer for no benefit.
Two things to check on an EDM drawing
First, the recast layer. The spark leaves a very thin re-solidified skin on the cut surface, slightly harder and more brittle than the parent metal. For most applications it is harmless. For fatigue-critical or medical parts it should be removed, and the drawing needs to say so, because removing it is an extra finishing operation.
Second, the corner radius. Designers sometimes draw a perfectly square internal corner on the assumption that EDM gives a true sharp corner. It gives a very small radius, not a zero one. State the maximum acceptable radius and the wire size follows from it.
Working with us
We run wire EDM and spark erosion alongside CNC milling, turning, turn-mill and grinding, which means a part can move between processes without leaving the shop. In practice most precision parts take a mixed route: milled and turned soft, heat treated, then wire cut and ground to final size. Send the drawing with the material and hardness condition noted and we will quote the sequence rather than a single operation.
